Factory-direct-hardware Hansgrohe 39400 Axor Citterio Manuel d'utilisateur télécharger pdf (Page 5)

Unscrew and remove the decorative nut cover.

Remove the handle screw (1).

Remove the green high temperature limit stop (2).

Replace it so that the pin goes into the hole for the

desired high temperature.

Reinstall the decorative nut cover (1). Tighten the

handle screw 4 complete turns (2).

Replace the handle (1). Finish tightening the handle

screw (2). Install the screw cover (3).

The temperatures shown in the diagram assume an

incoming hot water temperature of 140

F and an

incoming cold water temperature of 50

1 2 3 4 5 6 7 8

Pas de commentaire

Factory-direct-hardware Hansgrohe 39400 Axor Citterio Manuel d'utilisateur Page 5