Factory-direct-hardware Hansgrohe 31063 Manuel d'utilisateur télécharger pdf (Page 12)

12

English

Install the pop-up drain

Remove the plunger.

Unscrew the drain outlet ange from the tee.

Unscrew the tailpiece from the tee.

Wrap the threads with Teon tape. Install the

tailpiece on the tee.

Install the sealing gasket on the ange.

Rest the ange in the sink outlet.

Install the mack gasket, friction ring, retainer

nut, tee, and tailpiece on the ange.

Tighten the retainer nut.

Place the plunger in the drain.

Install the two pivot ball seals on the ball rod.

Install the ball rod on the tee. The end of the

rod must go through the loop in the bottom of

the plunger.

Tighten the pivot ball nut.

Slide the link over end of pull rod. Tighten the

screw.

Test the drain. Reposition the link on the ball

rod if necessary.

When satised, install the spring clip on the

ball rod.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire