Factory-direct-hardware Hansgrohe 14314 Talis C Manuel d'utilisateur télécharger pdf (Page 7)

Four-Hole Models only

Install the pin on the diverter.

Press the guide bushing rmly into place.

The hole in the pin should be clearly visible

through the slot in the guide bushing.

Lubricate the diverter o-rings using white plumb-

ers grease.

Press the diverter assembly rmly into the spout

tee until it is fully seated.

Firmly press the spout over the diverter.

Tighten the screw using a 3 mm Allen wrench.

Do not overtighten the

screw.

Overtightening the screw

will deform the o-rings,

causing a leak.

Install the diverter rod. The threaded end of the

diverter rod must go into the hole in the pin.

3 mm

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Pas de commentaire

Factory-direct-hardware Hansgrohe 14314 Talis C Manuel d'utilisateur Page 7